V-coat
V-coat
Application
– Single mesh waterproof (when the roof is single, red brick buildings, etc.)
– Concrete, molten
– Slate, gypsum board
– External waterproofing of wood plywood, etc.
– Crack prevention waterproofing
– Old churches, cathedrals.
– Dry bit when there are defects after water-repellent construction
– Concrete, molten
– Slate, gypsum board
– External waterproofing of wood plywood, etc.
– Crack prevention waterproofing
– Old churches, cathedrals.
– Dry bit when there are defects after water-repellent construction
Product configuration
It is penetrating coating waterproof agent that can completely prevent other cracking and contraction and expansion of the building after drying with special material having strong penetration, adhesion, water resistance, elasticity, weather resistance, acid resistance, and alkali resistance.
Product characteristics
– It is penetrating coating waterproof agent that can completely prevent other cracking and contraction and expansion of the building after drying with special material having strong penetration, adhesion, water resistance, elasticity, weather resistance, acid resistance, and alkali resistance.
– It is waterproof solvent where elasticity is 1,500% and cracking does not occur on the membrane even when cracking occurs on the building due to contraction and expansion.
– It has strong adhesion to cement and provides excellent weather resistance, water resistance, contamination resistance, and penetration.
– It is easy to conduct work and the membrane (water, oil, coal tar) does not have to be removed regardless of the material in the building.
– It has elasticity in low temperature (-20℃) and is suitable for external walls, roof and tile joints.
– If top coating applied with elasticity is required, “V-coat” should be used.
– It becomes hard in temperatures below zero, but changes into liquid in temperatures above zero while not causing any impact on product performance.
Product characteristics
| Maximum elongation rate | 1,500% | Paint available for top coating | Water type, oil type | ||
| Tensile strength | 18kg/㎠ | Ignition point | 35℃ | ||
| Composition | Single liquid (natural drying) | Heat resistance temperature | 60℃(Dried membrane) | ||
| Specific gravity | 0.91 | Drying(20℃) | Hard dry | Time available for top coating | |
| Painting device | roller,spray,brush | Time | 30minute | 2hours | |
How to use and caution
| How to use | – Remove foreign substances such as dust from the construction surface before painting. – Construction place should be dried sufficiently. – It becomes hard in winter season and it should be changed into liquid in temperatures above zero for construction. (It can be used after putting the can in warm water.) – Construction should be carried out two times on the roof. – Remaining paint can be sealed for reuse later. |
|---|---|
| caution | – It should not be mixed with other paint. – Be careful of access to flammable devices, access by children, and contact on the skin or eyes. – Pay attention to ventilation when working in sealed spaces. – Penetrating coating waterproof solvent (V-coat) has strong penetration into concrete and excellent elongation rate (stretching like rubber), which can be applied for maintenance work in roofs where cracks or vibration are severe. – In case of using roller, static electricity might cause fire outbreak when friction is excessive on the construction surface. ((In particular, be careful in winter season.)) |