Champion
Product configuration
With strong adhesion beyond compare, Champion does not require primer (mixing) process. It is designed for places where general type painting such as non-absorptive tiles, glossy tiles, and panels are not allowed, so waterproofing is possible for external walls without yellowing. It is a state-of-the-art new material using ceramic that can satisfy 3 effects with one construction.
Product characteristics
– It has strong adhesion, which does not require primer process.
– It uses 2-time construction for minimizing process.
– It has an excellent elongate rate to thin membrane (50um), which can effectively respond to cracks.
– Tacking (becoming sticky) does not occur after construction, so contamination does not occur.
– With its water repellent effect, cleaning can be done automatically after raining.
– There is little to no yellowing.
– Elongation rate is excellent. (General water paint does not have excellent elongation rate.)
– Viscosity is approx. 2,000CPS ± 100.
Product characteristics
| Rough surface (dryvit, brick) | Approx. 40 m2 |
| General surface (plaster surface) | Approx. 70 m2 |
| Smooth surface (tile) | Approx. 100 m2 |
| Tools | roller, brush,spray |
How to use and caution
| How to use | – Painting condition is when the air temperature is 10–30℃ and relative humidity is 85% or less. – Mix the paint sufficiently before construction. – Pour 1 cup of water for 1st construction depending on the temperature. – Carry out 2nd construction without pouring water. * Aqueous paint can be used for mixing color. (basic color:semi-glossy white color) * Minimum amount for mixing color is at least 50 packs. (pastel color is possible) |
|---|---|
| caution | – Concrete surface should be sufficiently cured (4 weeks or more at 20℃), and apply paint when pH is 8–9 or less and moisture content is 8% or less. – Aqueous paint should be stored in indoor areas (at room temperature of 5℃ or higher) that can avoid direct light. – If surface processing is insufficient, it might lead to poor adhesion and detachment of membrane. – In case of exceeding recommended amount (within 10%) of diluent (water), it might lead to reduction in material property. – Primer (mixing) can be lifted with stronger adhesion compared to primer (mixing) process, so primer (mixing) process should be omitted. – Pour 3 cups of diluted water for painting 18kg of Champion on the membrane and carry out 1st and 2nd construction. – If primer (mixing) process has been carried out by mistake, carry out drying for 24 hours or more before construction. |