Heat Reflective & Waterproof Paint (for Exterior wall)
Heat Reflective & Waterproof Paint (for Exterior wall)
19HRWP-E
Application
– All buildings for outdoor use- Non-absorbing tiles (glittering bricks)
– Panel, repainting on paint
– Dry bit, stone coat
– Concrete, etc.
– Panel, repainting on paint
– Dry bit, stone coat
– Concrete, etc.
Product configuration
Heat Reflective & Waterproof Paint (for Exterior wall) is a heat-resistant and water-resistant high-level product designed to be constructed in places where general paints such as non-absorbing tiles, shiny tiles, and panels are not allowed to be attached through strong adhesion. It is easy to construct due to unnecessary primer process, and the water-repellent function does not cause stains and no sulfur change. It is a cutting-edge new material with ceramic application that satisfies 3 effects at the same time with a single construction.
Product characteristics
– This is the exterior wall and exterior shield and waterproof functionality.
– Strong adhesion makes it so processless.
– Minimize the process by 2 times construction.
– Thin coating (50um) also has excellent elongation to counter crack.
– There is no tack after construction, so it does not get contaminated.
– It is a functional paint that automatically cleans when it rains after construction due to the water-repellent effect.
– There is very little yellow variation.
– Strong adhesion makes it so processless.
– Minimize the process by 2 times construction.
– Thin coating (50um) also has excellent elongation to counter crack.
– There is no tack after construction, so it does not get contaminated.
– It is a functional paint that automatically cleans when it rains after construction due to the water-repellent effect.
– There is very little yellow variation.
Product characteristics
| Product volume | 18L | Tools | Airless, roller, brush | ||
| Color | White **Mixing color is possible (contact manufacturer) |
Recommended dry membrane | 50㎛ | ||
| Painting type | Liquid type | Theoretical painting area | 4.67㎡ /ℓ | ||
| Thinner | Water | Construction area | Rough surface (dry bit, brick, etc): 40㎡ General surface (plain scene): 70㎡ Smooth surface (tile, etc.): 100㎡ |
||
| Mixing ratio | Less than 10% | ||||
How to use and caution
| How to use | – Painting conditions are 10–30 degrees in air and 85% in relative humidity. – Use sufficient stirring of paint before construction. – For the first construction, pour about 1 cup of water into the paper cup depending on the temperature. – Construct secondary construction without adding water. * Color can be colored with water-based paint pigments. (Basic color: half-light white) * The minimum quantity for our color production is 50 pieces or more. (Pastel color available) |
|---|---|
| caution | – Concrete should be sufficiently cured (based on 20 degrees, for more than 4 weeks) and paint only when pH is below 8~9 and the water rate is below 8%. – As it is water-based, avoid direct sunlight and store it in a cool room (room temperature of 5 degrees or higher). – If surface treatment is insufficient, it may cause poor attachment or peel off of the coating, so treat it completely. – Exceeding the recommended use of diluent (water) may cause poor physical properties. – If you have carried out the primer process, you may bite the primer with several times stronger adhesion, so make sure to skip the primer process. – When repainting on the old paint film, dilute the champion 18 kg water by 3 cups in a paper cup and proceed with the first and second construction after applying it as a substitute for a primer. -If the primer process is carried out by mistake, dry it sufficiently for more than 24 hours before construction. |